Smoked Tail Light Overlays - 2015-2021 Subaru WRX / STI

Smoked Tail Light Overlays — 2015–2021 Subaru WRX / STI

Give your WRX or STI a blacked-out, aggressive look without touching the factory tail lights. These precision-cut vinyl overlays wrap directly over your OEM lenses for a clean, seamless finish that looks factory-installed. Available in Dark Smoke, Light Smoke, Red, Yellow, and Chameleon.

Overview

Each kit includes a pair of overlays (driver and passenger side) designed to cover the reverse light and turn signal areas. Dark Smoke is the darkest option; Light Smoke is approximately half the darkness. Chameleon shifts color depending on viewing angle and lighting conditions.

Features

• Precision-cut for 2015–2021 Subaru WRX / STI
• Available in Dark Smoke, Light Smoke, Red, Yellow, and Chameleon
• Comes as a pair (left + right)
• Removable without damaging OEM tail lights
• Chameleon variant includes a protective film layer

Fitment

• 2015–2021 Subaru WRX
• 2015–2021 Subaru WRX STI

Installation

1. Clean the tail light surface thoroughly.
2. Use a wet install method — mix water and a small amount of dish soap in a spray bottle.
3. Start placement from the bottom corner closest to the trunk.
4. Spray the surface and the overlay, then position and slide into place.
5. Use a soft squeegee or your fingers to push out air bubbles from the center outward.
6. Allow to dry in sunlight or use a hair dryer on low heat to accelerate curing.
7. Once fully dry, the overlay is safe for power washing and automatic car washes.
8. Note: Chameleon overlays have a thin protective layer — peel it off after installation.